AMEPA presents new AMEPA Report software at METEC

14 May 2019

At METEC exhibition, AMEPA will present the new AMEPA Report software which automatically analyses the measured values of the slag detection sensors in the steel mill using new methods of digital signal processing.

The AMEPA Report software analyzes the measured values of the ESD sensors with digital signal processing and automatically evaluates the data based on rules. On casting ladles, measured values deviating from the nominal values are detected very quickly, for example in the area of the well block, upper nozzle or slide gate. This is done without taking the time to track individual value curves. This evaluation can also be used to schedule maintenance work.

All status messages are presented to the steelworker in table form, and the measurement results in graphic form. The results can be sent automatically to previously configured user groups as shift or daily reports in the form of e-mails at specific times.

The software allows the user to adapt the parameters of the ESD system to the user's product range. Remote maintenance and access to data for online customer support by AMEPA specialists are also available.